SS, feed coolant and drain, lines for 2860
#7
Elite Member
Thread Starter
iTrader: (9)
Join Date: Sep 2008
Location: Michigan
Posts: 5,609
Total Cats: 13
I dont see that happening. I just called the only hydraulic hoses shop that came out on yellow pages. Heres what I was told:
First I asked about AN fitting and they work with such fittings, only metric. The prices are
1/4" Hose (Total estimated length) $58
5/8" Hose $33
1/4" Brass Fittings $54.78 ( $9.13/ea)
5/8" Brass Fittings $41.66 (20.83/ea)
Labor $40 ($10/ea)
Total 227.44
and then all the other male fittings that go at around $12/ea for the feed. The drain ones Ill say $20 or so, washers.. ect... Put me in the $300 neigboorhood
looks like Im gonna have to wait.
First I asked about AN fitting and they work with such fittings, only metric. The prices are
1/4" Hose (Total estimated length) $58
5/8" Hose $33
1/4" Brass Fittings $54.78 ( $9.13/ea)
5/8" Brass Fittings $41.66 (20.83/ea)
Labor $40 ($10/ea)
Total 227.44
and then all the other male fittings that go at around $12/ea for the feed. The drain ones Ill say $20 or so, washers.. ect... Put me in the $300 neigboorhood
looks like Im gonna have to wait.
#10
Tour de Franzia
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
why not just buy the ss hose from summit, buy some stylish AN fittings, and make my own? It would make my life a lot easier, then I could sell you my old water and oil SS lines.
Is this a bad idea?
Is this a bad idea?
#14
I can sell you an oil feed kit for 90-95 motors for $35. Includes 7/16-24 inverted flare to -3an male fitting (turbo side), M10x1.5 to -3an fitting (block side), and 22" ss braided line with 90 degree fitting.
I can also sell you a oil return kit for $30 but it won't be ss braided or use AN fittings (what the reasoning behind that anyway...the line sees no pressure)
I can also sell you a oil return kit for $30 but it won't be ss braided or use AN fittings (what the reasoning behind that anyway...the line sees no pressure)
#16
Elite Member
Thread Starter
iTrader: (9)
Join Date: Sep 2008
Location: Michigan
Posts: 5,609
Total Cats: 13
Braided SS
-4 AN
Teflon lined
What's ideal for inside diameter, for feed and drain??
EDIT: heres the link http://www.summitracing.com/parts/AE...5/?image=large
Last edited by buffon01; 09-09-2009 at 04:29 PM.
#19
Elite Member
Thread Starter
iTrader: (9)
Join Date: Sep 2008
Location: Michigan
Posts: 5,609
Total Cats: 13
It is a good deal, and yes I do know where the feed is. However I talked to begi's people and I was told the feed is more or less 26".
EDIT: I'll deal if you accept return and bitching of my part if it doesnt fit.
EDIT: I'll deal if you accept return and bitching of my part if it doesnt fit.
Last edited by buffon01; 09-09-2009 at 06:39 PM.