WTB fab 9 COPS
How soon and what application? I'm going with a different setup, and the FAB9's on my car are about to be replaced. I'm running fully sequential so all the trigger wires aren't plug and play into a harness.
Reply
0
0
Junior Member
Joined: Jan 2014
Posts: 476
Total Cats: 13
From: Port Saint Lucie,FL
I have a set from my 99. I ran it wasted spark/pnp for a while, then cut 2 of the trigger wires and ran them to my megasquirt to run sequential ignition.
If you have a different year, and using an aftermarket ecu, you can just cut off the connector and hard wire straight to your ecu.
Also, the coils need a plug with a removable tip. If I can find the Denso's that came with it, I can throw them in too. I used them for a few months at about 10 psi.
$200 shipped
I'm off work today, can ship this afternoon.
If you have a different year, and using an aftermarket ecu, you can just cut off the connector and hard wire straight to your ecu.
Also, the coils need a plug with a removable tip. If I can find the Denso's that came with it, I can throw them in too. I used them for a few months at about 10 psi.
$200 shipped
I'm off work today, can ship this afternoon.
Last edited by Mech5700; Sep 24, 2015 at 10:25 AM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
