NEED a 1.8L HALFSHAFT
04-10-2008, 04:31 PM
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
use your old 1.6L shaft....just pop the flange section off each and swap.
the circlips are a bitch, but the only difference between the two is the flanges to the stubs are larger on the 1.8L.
the circlips are a bitch, but the only difference between the two is the flanges to the stubs are larger on the 1.8L.
0
04-10-2008, 10:09 PM
#4
Elite Member
iTrader: (21)
Join Date: Jun 2006
Location: Point Pleasant, NJ
Posts: 2,957
Total Cats: 2
i just was cleaning out some of my parts from a friends garage and came across a 94 half shaft. its stuck in the hub though so you'll need a press to get it out. it's from my ABS car so it has that sprocket on it. won't make any difference though, i have NB abs axles in my base 94.
yours for free if you want to come get it.
yours for free if you want to come get it.
0
04-10-2008, 10:10 PM
#5
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
oh........well that puts a damper on things....
the front hub section should still be swappable....FWIW, I put my 1.6L hub sections on my 1.8L axle shafts because i needed the ABS rings.
the front hub section should still be swappable....FWIW, I put my 1.6L hub sections on my 1.8L axle shafts because i needed the ABS rings.
0
Thread
Thread Starter
Forum
Replies
Last Post
jeffsl
Miata parts for sale/trade
6
02-23-2007 05:07 PM
