Aidan's loose oily bunghole actually runs a track lap
#3544
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
<p>13.4???</p><p>How does that picture tell you anything. it doesnt tell me where the top of the caliper is.</p><p>or how far away</p><p>or anything</p>
#3552
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
<p>This is sounding like a software problem, so who knows how long it will be.</p><p>Track day purchased for next thursday.</p><p>Doing a buddies transmission swap friday in exchange for bumper, mirror, trunk, 1.8 rear brakes.</p><p>Not a bad deal.</p><p>I also need to install the wells tps, rewire the harness, do some AE tuning, see if my catchan works.</p><p>i miss boost</p>
#3556
The picture you took is with the piece of aluminum resting on the wheel mounting surface, right? If so I think you are golden. It looks a lot like the pic I posted of the location of the hump on my 15x9 Dial Ins. My 15x7 wheels locate the interfering hump about 1" over and is the reason I can't fit 11.5" rotors under my 15x7's. You should be good to go.
#3558
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
<p>Mine looks like it could be maybe an 1/8-1/4 inch farther in than the 15x9. But a lot better than the x8.</p><p>Rotors should be here today. Woke turbofan up and stole his BP-10s. Centering rings showed up in the mail a few days ago.</p>
#3560
SadFab CEO
iTrader: (3)
Join Date: Sep 2012
Location: your mom's house phoenix, AZ
Posts: 4,560
Total Cats: 1,142
I want 3D printer. Since I know nothing of these, whats the bare minimum to get into one? I know its a vague question, but I donmt know what im asking. maybe 10" minum envelope?