Aidan's loose oily bunghole actually runs a track lap
#7824
You should be fine as you have the same sensor I now have. The one delivered with the LC2 was the problem. Two of them, not one, did the same thing. Without changing anything (wiring, ground points, etc) but the sensor for a genuine Bosch 17025, everything has been fine for months. I highly suspect the sensor that comes with the LC2 is not a genuine Bosch sensor as it's missing the laser etching and is just a *bit* different in some very minor stuff, but I have no other proof to back up the claim.
#7825
Elite Member
iTrader: (37)
Join Date: Apr 2010
Location: Very NorCal
Posts: 10,441
Total Cats: 1,899
Also LC2 with Bosch 4.2, no issues even after letting it sit idle in the downpipe for nearly a year. I bought like 4 sensors when Advanced Auto had them on super sale plus I had a coupon.
I'm sure all the oil in my exhaust is keeping it well protected
I'm sure all the oil in my exhaust is keeping it well protected
#7828
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Nevermind. I think you just need the firmware upgrade:
Bosch LSU 4.2 and LSU 4.9 Multi-Sensor Support
Bosch LSU 4.2 and LSU 4.9 Multi-Sensor Support
#7829
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Got a couple more things in the mail
Drain for the catch can
4 port boost controller. With a china special 3* adapter
Only good to 120psi. Still looking for something that will handle more boost.
Drain for the catch can
4 port boost controller. With a china special 3* adapter
Only good to 120psi. Still looking for something that will handle more boost.
#7835
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
It will need to be surfaced anyways after welding. So whats the point...
I'll just use an endmill. And it will seal just fine. or it might leak a teeny bit. but who really cares...
We also have a huge planer at work, might ask one of the guys to run it.
I'll just use an endmill. And it will seal just fine. or it might leak a teeny bit. but who really cares...
We also have a huge planer at work, might ask one of the guys to run it.