what psi spring for tial bov/wg?
11-03-2012, 12:08 AM
#1
Senior Member
Thread Starter
iTrader: (12)
Join Date: May 2008
Location: Roselle, Illinois
Posts: 849
Total Cats: -34
what psi spring for tial bov/wg?
I have a tial 38mm wg and a knock off tial 50mm bov. How do i determine what spring to use? should the waste gate and bov have matching psi springs? I plan on using a EBC.
Reply
0
0
11-03-2012, 09:04 PM
#4
Senior Member
Thread Starter
iTrader: (12)
Join Date: May 2008
Location: Roselle, Illinois
Posts: 849
Total Cats: -34
has anyone had any experience with these kncok off tials? any issues? I searched and found like one post which i think was done by tial showing failure.
Reply
0
0
11-03-2012, 10:32 PM
#5
few people on here use them.
no ill reports that I saw aside from having to fiddle with different springs to figure out what you need since they come with useless springs.
obviously tial is going to make them seem like completely worthless pos' cause they're stealing their business
no ill reports that I saw aside from having to fiddle with different springs to figure out what you need since they come with useless springs.
obviously tial is going to make them seem like completely worthless pos' cause they're stealing their business
Reply
0
0
11-04-2012, 12:09 AM
#6
Senior Member
Thread Starter
iTrader: (12)
Join Date: May 2008
Location: Roselle, Illinois
Posts: 849
Total Cats: -34
well i just pull it out of the package and started to dry fit it together and the banjo bolt will only go int he vacuum port 1 thread! so i just sent a email to the seller. other then the thread it feels like a nice piece. I may just have to use a tap to clean the threads but its probably npt?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
