Halcyon

iTrader: (1)

Currently I'm running a JRSC (yes, yes, I know) with bipes and powercard to control timing and fuel. It runs fine but I think I could squeeze out some more power with some fine tuning.

If I get the Emanage Blue, what other harnesses do I need to make it work with my 94 miata? Would I benefit from 305cc injectors?

I've posted this on miata.net as well but I figured you guys would be more knowledgeable.

Thanks

messiahx

iTrader: (2)

I bought a plug and play harness for my EMB from Boomslang Fabrication - The Performance Wiring Specialists. Otherwise you can buy the injector and ignition harnesses separately and wire them in yourself.

The 305s will give you more fuel, so you could up your boost a little bit. I don't know what JRSC flows, but the 305s I believe will give you enough fuel to run 7-8 psi max on a smaller turbo like a gt2554 with stock fuel pressure.

Halcyon

iTrader: (1)

Thanks for the link, that's what I was looking for.
I'm currently running 7-8psi on stock injectors cleaned by witchhunter so anything would be an improvement.

Halcyon

iTrader: (1)

So if I get this cable I wont need to do any cutting and splicing?
I looked at the thread here with the emanage installation on a 1.6 and that's a little more than I want to do.

messiahx

iTrader: (2)

Correct, the boomslang is plug and play. No cutting and splicing.