Need help with Autometer WBO2 and e-Manage Ultimate.
#1
Need help with Autometer WBO2 and e-Manage Ultimate.
I've searched Google like a bandit and this forum as well. I found this thread where another member was working to get the AM gauge working with the EMU, but I couldn't PM him due to my noobishly low postcount.
So...
Here's the issue. AutoMeter WBO2 gauge outputs a 0v-4v signal. e-Manage is looking for a 1v-5v 0v-5v* input. Finding the right values to put in the EMU wideband setup has so far been an inconsistent hunt-and-peck challenge.
Has anyone successfully coerced these two devices to play nice? Any suggestions would be appreciated.
Thanks.
*EDIT - It's 0v-5v, not 1v-5v. This misunderstanding is what made everything more complex than it needed to be. I'm going to set the gauge output low-high to 10-20 and the emanage wideband settings low-high to 10-22.5 and that should fix the issue. Will confirm if it works.
-SD
So...
Here's the issue. AutoMeter WBO2 gauge outputs a 0v-4v signal. e-Manage is looking for a
Has anyone successfully coerced these two devices to play nice? Any suggestions would be appreciated.
Thanks.
*EDIT - It's 0v-5v, not 1v-5v. This misunderstanding is what made everything more complex than it needed to be. I'm going to set the gauge output low-high to 10-20 and the emanage wideband settings low-high to 10-22.5 and that should fix the issue. Will confirm if it works.
-SD
Last edited by mk2tmr2; 12-29-2009 at 03:12 PM.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM