Link + LC1 - Miata Turbo Forum - Turbo Kitten is watching you test compression.

Ken Hill · **Link + LC1**

Does anyone have experience with this combination? I have '96 FMII with an Obiwan Link ECU. The car was brought to me for tuning with an LC1 WBO2 with a G3 gauge. The gauge accurately displays the A/F but the value from the sensor displayed in the Link is wrong. Full rich reads 103 and full lean reads 126. This is backwards according to the volt vs. A/F table for the LC1. Is there an incompatability issue with the Link ECU?

Thanks,
Ken

**Ben** · 09-25-2011, 09:39 PM

The LC1's analog outputs are user programmable on a 2 point linear curve, 0-5V output. Check the calibration and change it to what you need. If you don't have the cd that came with the LC1, you can download the Innovate software package off their website.

Ken Hill · 09-26-2011, 06:51 AM

Thanks for the tip, but I have already done that.

Ken

m2cupcar · 09-26-2011, 08:45 AM

Ken-
I used these setting's from lightweightmiata.com with success:

Quote:
	Z26 = 65 (14.8:1) Z27 = 66 (14.7:1) Z28 = 72 (14.0:1) Z29 = 84 (12.5:1) Z30 = 93 (11.5:1) Z26 = 102 (10.5:1)

xls reference file

http://www.lightweightmiata.com/beast/

Ken Hill · 09-26-2011, 01:02 PM

Thank you. This is just the information I was looking for as confirmation for my numbers. I did not install the LC1 in this car so I will now dig into the wiring to see if I can find the problem.

Ken

wanttoknow · 09-28-2011, 03:45 PM

Did you ever find a resolution to this? I am facing the same issue it looks like.

Thanks!
Lee