Cam pulley bolts?
#5
My cam pulleys are uncovered. The stock bolts look tatty but, more importantly, I can not get the washer they sit on to locate centrally and it makes the pulleys look as if they are wobbling when the engine is running. Stainless steel or titanium bolts with a shoulder or tighter fitting washer would look better and not 'wobble'.
#6
I can dig it, in for an answer.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#7
Elite Member
iTrader: (15)
Join Date: Sep 2007
Location: Incline Village, NV
Posts: 2,034
Total Cats: 5
I can mail you an extra set, but i don't have the tools to figure out what the thread pitch is. Why not take one of them out and run down to a hardware store and compare? Thats what i generally do.
#9
You are quite right. I am installing an ATI damper in two weeks time - so I'll be able to pull the bolts then. I was hoping to obtain the bolt specs earlier than that so that I could just swap them over at that point.
Edit: Actually I've just had them mailed to me.Now to try and find something in stainless steel or titanium.
Edit: Actually I've just had them mailed to me.Now to try and find something in stainless steel or titanium.
#10
Done those titanium bolts when I finally got around to the ATI superdamper install (it's under that link)...
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM