FS: Innovate XD-16 Gauge
#1
Senior Member
Thread Starter
iTrader: (10)
Join Date: Feb 2007
Location: South Eastern Wisconsin
Posts: 1,274
Total Cats: 0
FS: Innovate XD-16 Gauge
My LC1/XD16 combo that I paid nearly $400 for has been sitting in a box since spring when I swapped my UEGO back in. The LC1 does not work, I do not know what is wrong with it, however I think it was one of the defective units but I couldn't find my reciept to get it RMAd. My friend insisted that I simply had a bad o2 sensor but I gave up and took it out.
The XD-16 is in great shape, I used it for a few start ups and at most two drives before the LC1 took a crap. I believe retail is around $230 so I would like to get $125 shipped for it. I will include all cables that would have come with the XD-16, and whatever else I have left from it.
The LC1 I am not expecting to sell, but if you are interested in it I guess throw something out there. I'll most likely end up tossing it this winter.
The XD-16 is in great shape, I used it for a few start ups and at most two drives before the LC1 took a crap. I believe retail is around $230 so I would like to get $125 shipped for it. I will include all cables that would have come with the XD-16, and whatever else I have left from it.
The LC1 I am not expecting to sell, but if you are interested in it I guess throw something out there. I'll most likely end up tossing it this winter.
#5
I rma'd one with no receipt, hell I wasn't even the original owner. AND it was my own damn fault (melted the control cable on the header).
Just go here, and fill out the form.
Contact Innovate! Technology, Inc :: For Wideband Air/Fuel Ratio Tuning Solutions
C
#6
Elite Member
iTrader: (15)
Join Date: Dec 2007
Location: San Antonio, Texas
Posts: 4,847
Total Cats: 27
+1 they will probably be willing to at least test it for you. If it tests OK then you know it was probably the O2 sensor.
I just went through this myself. Long story short I was having E8 problems. I returned the LC-1 with an RMA (no receipt BTW) and they tested it for me. The LC-1 itself tested good. I am going to reinstall it with a new sensor, and triple-check my wiring.
I just went through this myself. Long story short I was having E8 problems. I returned the LC-1 with an RMA (no receipt BTW) and they tested it for me. The LC-1 itself tested good. I am going to reinstall it with a new sensor, and triple-check my wiring.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM