Bandsaw Help
#1
Bandsaw Help
I've tried digging around and I can't figure out a solution for this. Was hoping you guys might be able to help.
I have a WEN 3970.
About 2/3 of the time when I start it, the motor tries to turn but the blade doesn't move. I've found that if I turn it off and manually rotate the belt by hand and then turn it back on I can get it running. I've tried adjusting the belt tensioner and got the drive belt as tight as I can by hand. Nothing seems to fix it though. Any ideas?
I have a WEN 3970.
About 2/3 of the time when I start it, the motor tries to turn but the blade doesn't move. I've found that if I turn it off and manually rotate the belt by hand and then turn it back on I can get it running. I've tried adjusting the belt tensioner and got the drive belt as tight as I can by hand. Nothing seems to fix it though. Any ideas?
#2
Elite Member
iTrader: (5)
Join Date: Oct 2011
Location: Detroit (the part with no rules or laws)
Posts: 5,677
Total Cats: 800
What is slipping? Drive belt on motor / wheel or the blade on the wheel?
Is the drive belt making proper contact? V belts need to make contact on the sides NOT in the root / bottom.
Is everything dry?
Is the drive belt making proper contact? V belts need to make contact on the sides NOT in the root / bottom.
Is everything dry?
#3
It's weird as there is nothing slipping. The motor is trying to turn and the belt or blade seems like it is being bound up somewhere. I'm going to go over all the bearings tonight and make sure they are turning freely. Is there anything I should use the clean up all the metal shavings other than a dry rag and air?
#6
Elite Member
iTrader: (5)
Join Date: Oct 2011
Location: Detroit (the part with no rules or laws)
Posts: 5,677
Total Cats: 800
Wait.
110v motor. I'm assuming it's got a starter capacitor on it. Now that I reread your initial post I think that could be your problem.
Also sort of verified that when you give it a push it takes off.
It should fire off nice and fast. The motor should be able to overcome the belt if it is being bound up.
110v motor. I'm assuming it's got a starter capacitor on it. Now that I reread your initial post I think that could be your problem.
Also sort of verified that when you give it a push it takes off.
It should fire off nice and fast. The motor should be able to overcome the belt if it is being bound up.
#8
Elite Member
iTrader: (5)
Join Date: Oct 2011
Location: Detroit (the part with no rules or laws)
Posts: 5,677
Total Cats: 800
If you have a DDM you can set it to ohms. If it's open or inconsistent readings it's smoked.
Make sure you disconnect obviously and short it out to discharge it first. I've been nailed before it isn't fun.
It should be labeled with the information to track down a new one if bad.
Make sure you disconnect obviously and short it out to discharge it first. I've been nailed before it isn't fun.
It should be labeled with the information to track down a new one if bad.
#11
So that didn't go as planned... got the new Dayton capacitor installed and the bandsaw started right up and worked great for about 2 minutes. Then POP, the capacitor exploded. I looked everywhere on it for a polarity + or - and couldn't find anything. Assumed it could be installed either way, but apparently not. Next plan is to order two capacitors and if it blows up again just install the next one opposite of the first.
Thread
Thread Starter
Forum
Replies
Last Post
Vashthestampede
Insert BS here
3
04-20-2010 01:33 PM