BRP Jackson Racing or 4 ribbed Eaton MP 62 Tensioner
#1
Senior Member
Thread Starter
iTrader: (11)
Join Date: Sep 2007
Location: Killen, AL, 35645
Posts: 794
Total Cats: 10
BRP Jackson Racing or 4 ribbed Eaton MP 62 Tensioner
Up for sale is a BRP Supercharger Belt Tensioner for A/C, Power steering Equipped 90-05 Miatas. This sturdy piece of equipment has been gently used and makes an incredible improvement over Moss 1st generation and 2nd generation supercharger tensioners. The best thing about this pully tensioner is that it allows up to two inches of tension adjustment, so that you never run out of adjustment (a big disadvantage for moss motors crap) Want to get rid of belt squeel and make changing belts a breeze, this is just what you need. Included is the Track Dog Racing idler pulley with machined angle to offset belt torque and maintain proper alignment. Asking 100 dollars plus shipping. Paypal is preferred!
#4
Senior Member
Thread Starter
iTrader: (11)
Join Date: Sep 2007
Location: Killen, AL, 35645
Posts: 794
Total Cats: 10
Yes it works with either the JRSC MP45 Supercharger or the MP62 Moss Motors, TDR, BRP Supercharger. I used to run a Jackson Racing MP45 setup. This is much better than Moss 1st Generation(belt removal and replacement is a breeze with BRP)and 2nd Generation(BRP allows extra 2 inches of tensioning travel compared to Moss 1 inch travel)
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM