Rear Deck with 6-1/2" Speakers
06-15-2014, 11:08 PM
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Jul 2011
Location: Grand Rapids, MI
Posts: 213
Total Cats: 48
Rear Deck with 6-1/2" Speakers
Not sure I will find a buyer for this on this site but I thought I would give it a shot!
This is a 90-97 OEM rear parcel shelf and carpet with holes cut in it for 6-1/2" speakers. The speakers are included as well. I had to get rid of this because I installed a roll bar, and the rear braces don't like to coexist with the speakers!
The carpet is in nearly perfect condition (the car only has 30k miles on it). There are two "spacer rings" that I made from 1/4" lexan which space the speakers off the deck slightly so that they don't "sink in" because of the surrounding insulation under the carpet. I did notice that the Lexan had some stress cracks in it where the speaker screws thread in, but it didn't cause any issues and they are still in one piece so I think they will be fine. The speakers are 2-way Pioneer TS-G1640R, rated for 160W max, 4 ohm impedance.
I am sure I have some finished installation photos somewhere but I have to look on my other computer for them. The install looks very clean - OEM like!
Asking $150 shipped, OBO. Best way to contact me is via email: mx592 at hotmail.com
This is a 90-97 OEM rear parcel shelf and carpet with holes cut in it for 6-1/2" speakers. The speakers are included as well. I had to get rid of this because I installed a roll bar, and the rear braces don't like to coexist with the speakers!
The carpet is in nearly perfect condition (the car only has 30k miles on it). There are two "spacer rings" that I made from 1/4" lexan which space the speakers off the deck slightly so that they don't "sink in" because of the surrounding insulation under the carpet. I did notice that the Lexan had some stress cracks in it where the speaker screws thread in, but it didn't cause any issues and they are still in one piece so I think they will be fine. The speakers are 2-way Pioneer TS-G1640R, rated for 160W max, 4 ohm impedance.
I am sure I have some finished installation photos somewhere but I have to look on my other computer for them. The install looks very clean - OEM like!
Asking $150 shipped, OBO. Best way to contact me is via email: mx592 at hotmail.com
Reply
1
1
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
russian
Miata parts for sale/trade
6
10-08-2015 03:01 PM
