FS: NIB BEGi chinacharger T25/T28
07-10-2010, 02:52 PM
#1
FS: NIB BEGi chinacharger T25/T28
T25/T28 chinacharger from BEGi, new in the box, comes fully dressed with all fittings, necessary mounting studs & gasket, clocked with turbo outlet down for an intercooler setup, ported wastegate. I have original BEGi receipt, paid around $450 for it. $280 shipped
Let me know if you have any questions.
Thanks for looking,
Jason
Let me know if you have any questions.
Thanks for looking,
Jason
Last edited by jcocke; 07-12-2010 at 06:47 PM. Reason: Updated
0
07-11-2010, 04:40 PM
#5
Junior Member
Join Date: Jul 2008
Posts: 113
Total Cats: 1
I believe they're 8.8:1 and also that they're .060" over unless they have been placed in a non-original box...
PM sent before this post, still very interested, just need to see/search if +1.5mm is going to be okay for 300+whp application...
After searching a little, I had been under the impression +1mm was the "safe limit", I feel like +1.5mm will be plenty safe and also allow me to get this BP to breath a little better in the higher RPMs. Therefore, based upon this slightly new information, as soon as I receive your paypal info, there will be +$300 in your account.
PM sent before this post, still very interested, just need to see/search if +1.5mm is going to be okay for 300+whp application...
After searching a little, I had been under the impression +1mm was the "safe limit", I feel like +1.5mm will be plenty safe and also allow me to get this BP to breath a little better in the higher RPMs. Therefore, based upon this slightly new information, as soon as I receive your paypal info, there will be +$300 in your account.
Last edited by NickC; 07-11-2010 at 05:09 PM.
0
07-11-2010, 05:19 PM
#6
My bad, they are .060" over...I don't know why I thought they were .040" over...84.5mm...duh.
I just measured them at 3.325", which would put them at 84.5mm.
Should put the compression around 8.5-8.8:1, depending on what you do with your head.
I just measured them at 3.325", which would put them at 84.5mm.
Should put the compression around 8.5-8.8:1, depending on what you do with your head.
0
07-13-2010, 11:39 AM
#9
Newb
Join Date: Jan 2010
Location: San Antonio, TX
Posts: 31
Total Cats: 0
I'm interested in the turbo. I can't send PMs yet so please shoot me an email at brzez@lyonsandrhodes.com so we can talk--thanks
0
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
kronikker
Miata parts for sale/trade
17
10-06-2015 10:18 PM
