1.6l miata COP conversion, walbro pump, megasquirt1 v3 (chicago)
11-09-2010, 09:34 PM
#1
1.6l miata COP conversion, walbro pump, megasquirt1 v3 (chicago)
cop and pump sold
megasquirt 1 v3 board picked i up on here and finished up the last bit that needed to be done based off the miataturbo wiki site. tested on my friends jimstim and seemed good but i never made a harness to run it on my car. $200obo comes with the ecu connector needed to make a harness and iogear guc232a usb to serial adapter with a 6 foot serial cable
megasquirt 1 v3 board picked i up on here and finished up the last bit that needed to be done based off the miataturbo wiki site. tested on my friends jimstim and seemed good but i never made a harness to run it on my car. $200obo comes with the ecu connector needed to make a harness and iogear guc232a usb to serial adapter with a 6 foot serial cable
Last edited by aarontrini85; 11-12-2010 at 06:17 PM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
