DIY Strut Brace With Master Cylinder brace
#1
Newb
Thread Starter
iTrader: (2)
Join Date: Apr 2009
Location: Mississauga Ontario Canada
Posts: 44
Total Cats: 0
DIY Strut Brace With Master Cylinder brace
Check it out, Im aware that I made a miscalculation and had to cut my bar in half and reweld it, but I definately feel a difference, in both braking and front end stiffness.
#6
Newb
Thread Starter
iTrader: (2)
Join Date: Apr 2009
Location: Mississauga Ontario Canada
Posts: 44
Total Cats: 0
Id love to post up a "how to" with pics, but my genious father deleted all of the pics I took for the process, something about my 16gb SD card not having enough space? I dont know, but the process was pretty simple:
1) make a mock up out of plywood and wooden dowel
Mine bolted in and cleared everything
2) Get materials
I used aluminum which I got for free from a friend, he owed me a favour
3) Start cutting
It was aluminum so I used a Jigsaw and wd-40 as a lubricant. I went slow and got pretty good cuts
4) Once I had everything cut to length I cleaned all my areas for welding, tacked it together, and welded it in assuming that my first calculations were correct
5) *this step is unneccessary if you measure twice* cut the tube in the middle and take out the section that is causing your strutbrace to be too large
6) Get a peice of aluminum to thread for the master cylinder brace, cut it on an angle so it mounts parallel to the ground once on the side of the strut brace
7) Drill and tap the master cylinder brace for a bolt
8) Measure twice, tack, check fit and go weld
9) Install and be UBER happy for FIRM brakes
1) make a mock up out of plywood and wooden dowel
Mine bolted in and cleared everything
2) Get materials
I used aluminum which I got for free from a friend, he owed me a favour
3) Start cutting
It was aluminum so I used a Jigsaw and wd-40 as a lubricant. I went slow and got pretty good cuts
4) Once I had everything cut to length I cleaned all my areas for welding, tacked it together, and welded it in assuming that my first calculations were correct
5) *this step is unneccessary if you measure twice* cut the tube in the middle and take out the section that is causing your strutbrace to be too large
6) Get a peice of aluminum to thread for the master cylinder brace, cut it on an angle so it mounts parallel to the ground once on the side of the strut brace
7) Drill and tap the master cylinder brace for a bolt
8) Measure twice, tack, check fit and go weld
9) Install and be UBER happy for FIRM brakes
#19
Newb
Thread Starter
iTrader: (2)
Join Date: Apr 2009
Location: Mississauga Ontario Canada
Posts: 44
Total Cats: 0
After I had everything installed, I felt a huge improvement on my brake feel, but the brace flexes upwards, guess the booster brace isn't not 100% parallel with the MC........
The brace itself works great though. I had to install a new engine and the mounts were slightly taller so now it rests on the engine when its bolted down. I'm considering copying bbuny's brace to the firewall. I thought about it at the time but I wasn't convinced that my current brace would actually make a difference.
The brace itself works great though. I had to install a new engine and the mounts were slightly taller so now it rests on the engine when its bolted down. I'm considering copying bbuny's brace to the firewall. I thought about it at the time but I wasn't convinced that my current brace would actually make a difference.