Wire from NB harness not soldered to board.
1 Attachment(s)
On my adaptronic harness included with the ECU, the middle connector, with the white wires has a wire not soldered to the circuit board. When looking top down its the third wire on the top row from left to right in the number 2 box. its just hanging there with an empty hole.
Is everyones like this? Considering this is supposed to be a parallel harness I would assume this is not correct. Though I'm just comparing to all the parallel harnesses that I used to make for megasquirts so I could be mistaken. I'll try to take a quick crappy picture. |
I'll put you on the list. It looks like it was a bad solder joint. First I've seen of that. I can get someone here to repair it for you, or I can get you a fresh harness either way I'll get you taken care of.
|
There is no evidence of any attempt to solder it from what i can tell on top, the wire itself has no solder on it. I can't see through the glue.
From what I can tell this is the pin for the knock input. I need the car running today to put it in storage so I'm going to throw things together today and once I have it in storage I can do whatever but it has to get to its final destination today or tomorrow. I don't mind fixing it, I just don't have a glue gun to recoat the backside. Maybe a harness swap would be the better option. Up to you, the knock sensor circuit won't keep me from getting things going. |
I see your evil eyes mr jerigan!!!!
|
Originally Posted by cjernigan
(Post 401542)
There is no evidence of any attempt to solder it from what i can tell on top, the wire itself has no solder on it. I can't see through the glue.
From what I can tell this is the pin for the knock input. I need the car running today to put it in storage so I'm going to throw things together today and once I have it in storage I can do whatever but it has to get to its final destination today or tomorrow. I don't mind fixing it, I just don't have a glue gun to recoat the backside. Maybe a harness swap would be the better option. Up to you, the knock sensor circuit won't keep me from getting things going. Travis |
I ended up soldering this wire back into the board. Piece of cake.
|
This happened on my mate's MSM Adaptronic harness too. His had actually bridged two sensor wires together so check them all carefully!
|
Nice. I found many poorly filled holes that I resoldered to make sure there were no issues. Two other obviously cold joints that I touched up as well. It should all be good now though.
|
What injectors are you running saboteur?
|
I'm using the 460cc RX-7 ones.
|
Did you have wires like this? Seems like they gauge they used does not even fit the holes.
http://img51.imageshack.us/img51/213/img4795h.jpg |
I think it's time to raise the cost by adding wire-to-board connetors so you dont have breaking wires.
|
All times are GMT -4. The time now is 04:07 AM. |
© 2024 MH Sub I, LLC dba Internet Brands