ARTech manifold/downpipe
Joined: Jun 2006
Posts: 29,085
Total Cats: 375
From: Republic of Dallas
Reply
0
0
Thread Starter
Senior Member
iTrader: (7)
Joined: Dec 2006
Posts: 1,376
Total Cats: 4
From: Chicagoland
TCC (People who coated my manifold) has had people bring that issue up as far as worrying the coating will break off, but he has done a lot of manifolds with no problems. All his stuff is warranted also not to chip/flake off, so I trust it, I forgot the thickness he does his coatings too.
And, as far as the tires...that's fully warm I do run 25psi and never have issues with traction even when cold. Like I said, all my power is over 4,000 RPM which helps a lot w/traction and I have some lag b.w gears so I don't spin all over the place. But, with 380 whp I couldn't go WOT until 4th even then I was sideways. So, I will need to adjust accordingly with the power increase with suspension adjusting and tires.
And, as far as the tires...that's fully warm I do run 25psi and never have issues with traction even when cold. Like I said, all my power is over 4,000 RPM which helps a lot w/traction and I have some lag b.w gears so I don't spin all over the place. But, with 380 whp I couldn't go WOT until 4th even then I was sideways. So, I will need to adjust accordingly with the power increase with suspension adjusting and tires.
Reply
0
0
Reply
0
0
.
Reply
0
0
Reply
0
0
Joined: Sep 2010
Posts: 8,146
Total Cats: 1,087
From: Lake Forest, CA
Reply
0
0
Reply
0
0
