Begi or ETD t3 manifold?
#4
The ETD supposedly has one bolt that is difficult to reach with a wrench but people say it's doable, just takes more time than most would like (middle bottom nut). The ETD should flow better, it's all up to you though man. If you want cast then get cast if you want a well flowing shorty tubular then get the ETD.
#5
I've debated between the two also. Turbo position on the Begi sits a little lower so depending on the turbo it can hit the "shelf" area of the chasses. The ETD turbo position from what I can tell sits higher which concerns me with how close it is to the braking system. You can address both potential issues so I'm going with cast manifold for reliability, and I'm not looking for that much power. hth
Last edited by tilt; 03-30-2008 at 08:11 PM.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
kronikker
Miata parts for sale/trade
17
10-06-2015 10:18 PM