BP-Z3 engine with VICS
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 79
Total Cats: 0
From: Zilina,Slovakia
BP-Z3 engine with VICS
I would like to install BP-Z3 (VVT) engine for my miata NB 00 turbo project.
I bought VVT engine without intake manifold, so I would like to use my old NB VICS manifold.
I have got MS2 ecu. Is it any way to control VICS solenoid by MS2? Where is a correct source of vacuum locate to control VICS butterfly after turbocharging?
I bought VVT engine without intake manifold, so I would like to use my old NB VICS manifold.
I have got MS2 ecu. Is it any way to control VICS solenoid by MS2? Where is a correct source of vacuum locate to control VICS butterfly after turbocharging?
Last edited by elektron; Nov 30, 2015 at 04:59 PM.
Reply
0
0
Newb
Joined: Aug 2013
Posts: 17
Total Cats: 0
From: Lexington, KY
I'm about to do something similar and its my understanding that there is a chamber inside the manifold that stores the vacuum until needed.
My Rev MS2e has built in control for VICS, not sure about other version however.
My Rev MS2e has built in control for VICS, not sure about other version however.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
vteckiller2000
Miata parts for sale/trade
4
Dec 12, 2015 08:17 PM
shuiend
Miata parts for sale/trade
10
Nov 30, 2015 02:22 PM
