Can I cut this off?
1 Attachment(s)
Can I cut this tab off of the transmission? It would make downpipe routing much easier. I put a picture with the tab circled. I'm sure people have done this, just making sure i wont mess up the newly replaced trans.
Attachment 191160 Thanks, Evan |
Yes you can. could have sworn there was just a thread about this either on here or on m.net.
|
is it a solid tab?
I remember wondering why its there when I was making my dp too, I don't see why you can't cut it off either |
Cut it off it will not hurt anything.
|
I think I cut mine off but cant remember.
|
That tab holds the flux transducer in place :?
|
I'd just like to point out that, given the nature of some of the conversations that take place on this forum, seeing a thread entitled "Can I cut this off?" makes me more than a tiny bit nervous.
|
And all the comments after it "yeah just cut it off it doesn't do anything anyway":laugh:
|
Originally Posted by Joe Perez
(Post 686935)
I'd just like to point out that, given the nature of some of the conversations that take place on this forum, seeing a thread entitled "Can I cut this off?" makes me more than a tiny bit nervous.
|
Ok so it does do something it is a casting in the side of the trans to hold the bracket that holds the original down pipe. To clarify my statement from earlier so I don't look like such an idiot. For what you are doing and being that most of the cars on this forum have custom down pipes for turbos you do not need this tab and it will not hurt anything to remove it.
|
Originally Posted by Joe Perez
(Post 686935)
I'd just like to point out that, given the nature of some of the conversations that take place on this forum, seeing a thread entitled "Can I cut this off?" makes me more than a tiny bit nervous.
|
All times are GMT -4. The time now is 07:04 AM. |
© 2024 MH Sub I, LLC dba Internet Brands