very nice build indeed. I too made my own SGDP but out of mild steel. I wish I could weld that good LOL.
Are you planing on putting an exhaust tip on it? If not you might want to extend your tail pipe a little. In one picture it apears to be sitting a little to far under the car, and you will burn the rear bumper cover. |
When the picture was taken the part of the cat was not in the spot where it is now. It sits right where i want it.
|
Completion of exhaust
9 Attachment(s)
Well finally done with it. Got the hangers welded on and painted with high temp paint.
Heres how i bent the exhaust hangers ( anvils ftw ) Attachment 205771 I decided the best route to make sure the hangers would fit is to weld them while they are attached ( yes i can weld underneith a car ) Attachment 205772 Proof! Attachment 205773 Heres what ive seen lots of people doing on there exhaust builds so i decided to do it too Attachment 205774 After i welded them up pretty solid i pulled it out and put the final welds on her Attachment 205775 Painted! Attachment 205776 I decided to move the heater line a bit to give my downpipe some room Attachment 205777 Little bit more! Attachment 205778 Ahh fuck too much. Its pinched now :vash: . Gives me a reason to pull off the manifold to make a better one. Also gonna clean out them combustion chambers for some ponies Attachment 205779 Heres the video. Enjoy http://i692.photobucket.com/albums/v...h_P5180023.jpg |
Good job brother!
|
Very nice work. Thinking about doing the same thing sometime soon. What downpipe flange is that? What does the greddy use, its very odd.
|
Incredibly impressed with both your welding and your work.
XSPower exhausts have worse welds than yours, you done a proper job there. May I ask if you have a JPG/BMP/etc of your td04 downpipe flange/mounting? I'm doing a similar project over the summer and was hoping to ease myself from some of the drawing :D |
All times are GMT -4. The time now is 06:39 PM. |
© 2024 MH Sub I, LLC dba Internet Brands