very nice build indeed. I too made my own SGDP but out of mild steel. I wish I could weld that good LOL.

Are you planing on putting an exhaust tip on it? If not you might want to extend your tail pipe a little. In one picture it apears to be sitting a little to far under the car, and you will burn the rear bumper cover.

When the picture was taken the part of the cat was not in the spot where it is now. It sits right where i want it.

Completion of exhaust
 

Well finally done with it. Got the hangers welded on and painted with high temp paint.

Heres how i bent the exhaust hangers ( anvils ftw )

Attachment 205771

I decided the best route to make sure the hangers would fit is to weld them while they are attached ( yes i can weld underneith a car )

Attachment 205772

Proof!

Attachment 205773

Heres what ive seen lots of people doing on there exhaust builds so i decided to do it too

Attachment 205774

After i welded them up pretty solid i pulled it out and put the final welds on her

Attachment 205775

Painted!

Attachment 205776


I decided to move the heater line a bit to give my downpipe some room

Attachment 205777


Little bit more!
Attachment 205778

Ahh fuck too much. Its pinched now :vash: . Gives me a reason to pull off the manifold to make a better one. Also gonna clean out them combustion chambers for some ponies

Attachment 205779

Heres the video. Enjoy

http://i692.photobucket.com/albums/v...h_P5180023.jpg

Good job brother!

Very nice work. Thinking about doing the same thing sometime soon. What downpipe flange is that? What does the greddy use, its very odd.

Incredibly impressed with both your welding and your work.
XSPower exhausts have worse welds than yours, you done a proper job there.
May I ask if you have a JPG/BMP/etc of your td04 downpipe flange/mounting?
I'm doing a similar project over the summer and was hoping to ease myself from some of the drawing :D