DSM stock J-pipe coupler
ok, here's a question:
Been planning on using the stock J-pipe (compressor outler pipe) that came stock on a DSM. But it's about a 1.75" OD, iirc. I'm planning on using 2" intercooler pipe. Any ideas where to find a reducer like that for < $mad bank$? Thanks |
|
mine was 2 inches hmm, and i used a peice of radiator line i also had to cut the j pipe to fit.
|
You want a 2" coupler.
|
Hmmm, I'll go make a more accurate measurement.
|
nah he says his is 1 3/4 OD i dunno
|
1 Attachment(s)
I'm talking about this piece in the attached photo.
Just measured with some calipers. Does indeed appear to be 1 3/4" I also measured my intercooler inlet/outlet again; they appear to be 2 1/16". That close enough to push on some 2" couplers? Thanks guys. I'll probably take a look at siliconeintakes.com |
Originally Posted by Atlanta93LE
(Post 76709)
I also measured my intercooler inlet/outlet again; they appear to be 2 1/16". That close enough to push on some 2" couplers?
|
Originally Posted by Atlanta93LE
(Post 76709)
I'm talking about this piece in the attached photo.
Anyways, place your coupler in boiling water for 5 minutes and you can easily get another 1/2" worth of diameter out of it. I used some KY for good measure and don't forget a glove of some sort. Check out this thread: https://www.miataturbo.net/forums/showthread.php?t=5332 |
1/2, eh? I've seen that thread before...very nice. Perfect to stretch some 2" over the 2 1/16" intercooler inlet/outlet.
Then I guess I'll just need a 1 3/4" to 2", and then a 2 1/4" to 3" for the compressor inlet. Neat stuff. I'll wait to order until I get the intercooler mounted and routing worked out more specifically. Thanks guys |
I have that 1-3/4" dsm pipe to, I used a 1.5->2" coupler.
|
Cool. Thanks.
|
All times are GMT -4. The time now is 08:07 AM. |
© 2024 MH Sub I, LLC dba Internet Brands