Garrett V band flange measurements
#1
Senior Member
Thread Starter
Join Date: May 2015
Location: Grand Rapids, MI
Posts: 504
Total Cats: -23
Garrett V band flange measurements
Either my turbine housing (atp v band gt2560r) is incompatible with normal garrett flanges or the wrong flanges are on my manifold and downpipe.
On the page with my turbine housing, atp lists related parts at the bottom of the page. (An inlet and outlet flange) those flanges fit gt28, gt30, and gt35. As far as I know, atp is the only seller of my turbine housing. So they must have the correct flanges, correct? Dont tell me there is a turbine housing for sale with no flanges that fit it. Please dont tell me that.
Anyway. Here are some pictures. Fab 9 mani/dp with "garrett" flanges.
Even better. I sent these same measurements in MM to fab 9s fabricator before he started and he said it would fit.
On the page with my turbine housing, atp lists related parts at the bottom of the page. (An inlet and outlet flange) those flanges fit gt28, gt30, and gt35. As far as I know, atp is the only seller of my turbine housing. So they must have the correct flanges, correct? Dont tell me there is a turbine housing for sale with no flanges that fit it. Please dont tell me that.
Anyway. Here are some pictures. Fab 9 mani/dp with "garrett" flanges.
Even better. I sent these same measurements in MM to fab 9s fabricator before he started and he said it would fit.
#2
Senior Member
Thread Starter
Join Date: May 2015
Location: Grand Rapids, MI
Posts: 504
Total Cats: -23
Pictures arent really in the right order but you can see that the lip on the inlet flange is too big to fit into the housing. And the outlet flange on the downpipe is bigger than the flange on the housing. Fwiw, inlet flange ODs match perfectly
#6
Senior Member
Thread Starter
Join Date: May 2015
Location: Grand Rapids, MI
Posts: 504
Total Cats: -23
Ive been digging for a few hours. I believe my housing is meant to receive tial flanges. Don't know how theh could get it wrong though since I sent them pictures with the calipers on every ID and OD on the housing and he said it would fit. Are there other garrett flanges on the market other than tial that they mightve used?
#10
Senior Member
Thread Starter
Join Date: May 2015
Location: Grand Rapids, MI
Posts: 504
Total Cats: -23
This sexy thing. Its a 2871 with a tial v-band housing.
Thread
Thread Starter
Forum
Replies
Last Post
brokenspoon420
DIY Turbo Discussion
29
07-27-2012 09:36 PM
sixshooter
Miata parts for sale/trade
9
06-21-2011 06:43 AM
Cody Strife
Prefabbed Turbo Kits
8
04-24-2009 11:20 AM