yes sir, pulling 12v from the blue connector's wire on the driver's side. I even double checked with a test light that voltage was present on the EBC side of the connection. The other wire from the EBC goes to pin 7, bottom left on the 4th harness. That is the extra harness that goes into the MSPNP.

Scott, thanks for your help thus far.

 

Can you hear the solenoid clicking at all?

 

Yeah, it clicks. If I lower the DC in the table it will get to wastegate pressure. So it works.

 

So as stated in another thread. The problem turned out to be a loose down pipe to turbine. Now, I hit full boost at 3900 before hitting the obp. I am going to swap turbos to see if I can get better spool right off the bat, then I will tune the EBC.