LC-1 gauge and MSPNP doesn't agree on AF value
#1
LC-1 gauge and MSPNP doesn't agree on AF value
There's about 0.5 in AF value difference between the reading on the MSPNP (89-93) and the LC-1 Gauge.
Anyone have a clue how to make them talk the same language, and to which one is correct?
The MS reads the signal to be leaner then the gauge, so either way, I'm running it richer. It's still not optimal though, so I'd like to figure it out.
Is it just a small adjustment to the MS, or do I have to get hard and handy?
It's been like this since I installed it, and both the LC and the MS was new.
Anyone have a clue how to make them talk the same language, and to which one is correct?
The MS reads the signal to be leaner then the gauge, so either way, I'm running it richer. It's still not optimal though, so I'd like to figure it out.
Is it just a small adjustment to the MS, or do I have to get hard and handy?
It's been like this since I installed it, and both the LC and the MS was new.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM