Oil at intercooler pipe?
#1
Newb
Thread Starter
iTrader: (1)
Join Date: Apr 2007
Location: Rincon City, Spain
Posts: 35
Total Cats: 0
Oil at intercooler pipe?
Hi,
Few days ago I found some oil leaking at intercooler pipe between turbo and the intercooler.
When I remove the pipes, there was a bit of oils, the pipe was wet with oil from turbo to intercooler.
I checked turbo, there is no shaft play, comp wheel is clean....
Why there is oil in the pipes????
I have oil catch can, is it's the problem?
Few days ago I found some oil leaking at intercooler pipe between turbo and the intercooler.
When I remove the pipes, there was a bit of oils, the pipe was wet with oil from turbo to intercooler.
I checked turbo, there is no shaft play, comp wheel is clean....
Why there is oil in the pipes????
I have oil catch can, is it's the problem?
#6
It is a bit tough to say how much is too much. Almost all turbos will seep some from the front seal and oil up the intake tubes. Certainly, the oil will gather at the low point and it will find a way past the tube/hose/clamp assembly.
I'd consider two aspects: If oil smoke is coming out the taipipe when driving, there is a problem. The turbo seals are suspect.
Second: If you pull the tubes loose and more than a spoon full of oil drips out, the front seal is at least of concern.
Keep in mind that oil fumes have a real low octane.
Corky
I'd consider two aspects: If oil smoke is coming out the taipipe when driving, there is a problem. The turbo seals are suspect.
Second: If you pull the tubes loose and more than a spoon full of oil drips out, the front seal is at least of concern.
Keep in mind that oil fumes have a real low octane.
Corky
#7
Cpt. Slow
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,224
Total Cats: 1,146
Holy spiders nest. You have more plumbing in there then...a plumbing store.
I think the catch can doesn't connect to the intake at all, so I'd say that's not your problem.
I'd say your turbo seals are shot. I did a DIY rebuild on my little SR20 turbo, and have zero oil in my pipes. Same with my old TD-04.
I find it ironic that you have a VTA filter on the line headed to your catch can.
I think the catch can doesn't connect to the intake at all, so I'd say that's not your problem.
I'd say your turbo seals are shot. I did a DIY rebuild on my little SR20 turbo, and have zero oil in my pipes. Same with my old TD-04.
I find it ironic that you have a VTA filter on the line headed to your catch can.
#8
Newb
Thread Starter
iTrader: (1)
Join Date: Apr 2007
Location: Rincon City, Spain
Posts: 35
Total Cats: 0
Thanks for everyone for the comment.
I have filter so many oil catch can comes with filter, the filter helps to evacuate cranckcase pressure.
This is my actual setup, but with PCV valve.
I think I have more than a spoon of oil...... so, I understand that the turbo seals is gone....
Just say that the turbo is new.... with less than 200km for test drive..... chinacharger....
I have filter so many oil catch can comes with filter, the filter helps to evacuate cranckcase pressure.
This is my actual setup, but with PCV valve.
I think I have more than a spoon of oil...... so, I understand that the turbo seals is gone....
Just say that the turbo is new.... with less than 200km for test drive..... chinacharger....
#17
I might be looking at this wrong, but do you have both sides of your valve cover vented into the same catch can and the only way for it to vent is the VTA in the line from the hot side? Does any of that catch can configuration route back to the intake?
For the catch can, try to T the two sides into the same side of the catch can and put the vent on the other side. This will help the mist that is forced out under high crankcase pressure collect in the can before pissing all over your blue engine bay. If none of this is routed back to the intake, it won't have diddly to to with the oil in the intercooler pipes but it may help the overall consumption.
For the catch can, try to T the two sides into the same side of the catch can and put the vent on the other side. This will help the mist that is forced out under high crankcase pressure collect in the can before pissing all over your blue engine bay. If none of this is routed back to the intake, it won't have diddly to to with the oil in the intercooler pipes but it may help the overall consumption.