Need an oil line...
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2004
Location: Haarlem ,the Netherlands
Posts: 453
Total Cats: 0
Need an oil line...
I need an oil line from the oil pressure sender to the turbo (nissan t25) .
Can anybody tell me the treath size of both??
Any info on the lenght off the hose??
Can anybody tell me the treath size of both??
Any info on the lenght off the hose??
#3
Junior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2004
Location: Haarlem ,the Netherlands
Posts: 453
Total Cats: 0
Sorry , no info on treat size or oil line length
Just found out the turbo treath is a 7/16-24 inverted flare.
Now the oil pressure port (passenger side)...
Also, no greddy... A t25/28 from a nissan. On a 1.6 without an oil pressure port on the exhaust side...
Just found out the turbo treath is a 7/16-24 inverted flare.
Now the oil pressure port (passenger side)...
Also, no greddy... A t25/28 from a nissan. On a 1.6 without an oil pressure port on the exhaust side...
#4
Found this older thread searching.
https://www.miataturbo.net/forums/sh...t=1.8+oil+feed
The block is 1/8 BSP. Line should be around 40-42", my 46" is too long.
https://www.miataturbo.net/forums/sh...t=1.8+oil+feed
The block is 1/8 BSP. Line should be around 40-42", my 46" is too long.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM