Oil/Water Line Knowlege Needed
 

I think I've got all my oil/water lines figured out now. Just want to ensure these are okay spots before i start cutting up and making things.
Oil feed: https://cimg9.ibsrv.net/gimg/www.mia...f0a44f4fb6.jpg
[will buy the TSE fella to put behind the oil pressure tiddlybit]
Oil Return: https://cimg2.ibsrv.net/gimg/www.mia...1ad02344e0.jpg

Water feed: https://cimg6.ibsrv.net/gimg/www.mia...48988d88e8.jpg[the oil bits will be cut off and i'll have an AN bung welded on]
Water Return:https://cimg1.ibsrv.net/gimg/www.mia...6d0e32a101.jpg
[will remove the plug and insert a little guy for AN lines]

Look solid or do I have it all wrong?

Do you have AC? That drain fitting looks a little bit high if you plan on using AC.

No AC and no front waterneck. :bigtu:

Subd because I'll need this eventually.

you do know this information is out there and readily available with a quick search?? Theres even a wiki about it.

Yeah. I know the oil lines should work fine, but the water ones are somewhat of an oddball setup.

water feed and return are switched

Ah.. I can see that now. Whoops. Would those two locations work good?

That is how i did my water lines

Double

Rad. Thanks.

just realized you have the pump return flipped...i did not do that. i welded a fitting where the hardline pressed into and ran -6 water lines. but same flow path.