I think I've got all my oil/water lines figured out now. Just want to ensure these are okay spots before i start cutting up and making things.
Oil feed:
[will buy the TSE fella to put behind the oil pressure tiddlybit]
Oil Return:

Water feed: [the oil bits will be cut off and i'll have an AN bung welded on]
Water Return:
[will remove the plug and insert a little guy for AN lines]

Look solid or do I have it all wrong?

 

Do you have AC? That drain fitting looks a little bit high if you plan on using AC.

 

No AC and no front waterneck.

 

Subd because I'll need this eventually.

 

you do know this information is out there and readily available with a quick search?? Theres even a wiki about it.

 

Yeah. I know the oil lines should work fine, but the water ones are somewhat of an oddball setup.

 

water feed and return are switched

 

Ah.. I can see that now. Whoops. Would those two locations work good?

 

That is how i did my water lines

 

Double

 

Rad. Thanks.

 

just realized you have the pump return flipped...i did not do that. i welded a fitting where the hardline pressed into and ran -6 water lines. but same flow path.