Turbo 1.6L NB6C jdm miata ms2 issues
 

Hey everyone i am new to the forum and im having a few issues with my miata.
i recently put a t28 turbo on along with injectors, head studs etc etc. im using a ms2. when i try and start it i have no spark or fuel. ive tired different maps, checked all my connections blah blah blah. its hard to find info for me as i have a 1998 NB miata but its a NB6C jdm miata. PLZ someone help me ive run out of ideas and would love to drive my car this year!

Go to Composite Logger. Do you have cam and crank signals?

No I have none of those signals

Where did the MS come from? Did you buy it used or from a vendor?

Bought it off 949racing new

If you are not seeing Cam and Crank signals when viewing logger, while cranking the engine, then they are not connected.... Check the blah blah

Everything is connected...this is my issue. Everything is connected but still get nothing

Well, then looks like time to sell it.

Not supper helpful...

Seems like the MS is not seeing the signal. Have you checked to make sure all the pins in the connectors are seated properly?

I have,everything seems good

No thanks, not hungry

"Seems" does not equal "is".

Pin out the terminals to make sure you don't have a broken wire somewhere. That will eliminate half of your possibilities.

How do you have your spark settings configured?

Edit: Wait, you have an NB with a 1.6?

Yeah all the wires are good I've probed the entire harness already. And yes I have the 1998 Nb that was only sold in Japan and Europe it has the 1.6. Rhd spark configurations I've used 1990-1994 start up maps and 1999-2000 start up maps nothing seems to work

The NB 1.6 didn't have the cas, it have crank and cam hall sensors, like the 1.8 NB.
I think you should use the 98-00 setups

I'll give it a try thanks! Anyone have a good start-up map that works good?

Does the nb6c come with a vtps too or no?

Yes, it has the 1.8 throttle body

What ecu should I be using? I have a mspnp2 for a 1.6 but could that be my issue??

What ecu should I use? I have a mspnp2 for a 1.6L could that be my issue. I don't think it would be but I could be wrong