Turbo Coolant/Water Line Size
2 Attachment(s)
Had a google, found no answers!
When running water lines from here https://www.miataturbo.net/attachmen...ine=1388869721 What internal diameter hose should be used? Cheers |
-3 for oil, -4 for water.
|
-4 being 4/16ths being 1/4"?
Sorry, I'm from England! |
I was using AN sizing
|
AN sizing only references the OD though yeah? When really I'm asking for the ID of the hose or the OD of the nipples on the car...
|
I think -4 is 5/16", -3 is 1/4"...that's off the top of my head. I'm positive -6 is 3/8" so I just scaled down. I custom did my lines in all braided with no barbed fittings, so I can only compare.
|
I used 1/4" ID.
|
1/16' = -1AN, so -4 is 1/4", -6 is 3/8", -8 is 1/2", etc. All the way up to -20AN which is 1 1/4".
I've typically used -6AN for water lines, but that's only because M14x1.5 to -4AN fittings can be hard to find. -4AN or -6AN is fine. |
1 Attachment(s)
Mick,
In my experience hose with an 8mm internal diameter is a good fit. I use steel braided hose with crimped banjo connectors on one end and and hose clamps on the other. https://www.miataturbo.net/attachmen...ine=1388934128 |
1 Attachment(s)
Hmmm I never even thought about what size my lines were... I got Artech's SS oil/water lines. Anyone know off hand what size these are?
https://www.miataturbo.net/attachmen...ine=1388934461 |
All times are GMT -4. The time now is 07:45 PM. |
© 2024 MH Sub I, LLC dba Internet Brands