is this turbo a viable option for a 1.6?
14 Attachment(s)
i have this sitting on the shelf in the garage. car is just for weekend fun driving as of right now. may occasionally autocross it in the future. moderate hp goal of 200ish.
garrett t3/t04e https://www.miataturbo.net/attachmen...ine=1404069557 compressor side .50 a/r https://www.miataturbo.net/attachmen...ine=1404069557 exducer https://www.miataturbo.net/attachmen...ine=1404069557 inducer https://www.miataturbo.net/attachmen...ine=1404069557 turbine side .84 a/r (would probably need to source a .48 or .64 housing i believe) https://www.miataturbo.net/attachmen...ine=1404069557 inducer https://www.miataturbo.net/attachmen...ine=1404069557 exducer https://www.miataturbo.net/attachmen...ine=1404069557 open to ridicule, humor, general input, your :2cents: |
I think that's pretty big. Especially for a 1.6. It's an interesting compressor wheel though. The inducer is pretty small compared to the exducer which is pretty big.
For comparisson, my EVO3 16G compressor is 48mm and 68mm. |
That's a diesel turbo hence compressor wheel ratio weirdness. You'll never spool it or be happy with it, but go ahead.
|
Go for it. Fuck it. if it all ends terrible, you will still have a T3 flange IIRC Manifold if you don't like it. Sell the turbo on Turbobricks, and buy/trade a smaller T3 flanged Turbo. Profit?
If you got the cash/Burning desire. Go for it. I wanna see it. I would love to throw a Hx30/35W on a miata just for kicks and shit if I had the disposable income to justify it. |
OP, get something less obscure. Don't build your car around a single part.
Originally Posted by 780racer
(Post 1144496)
Hx30
https://www.miataturbo.net/build-thr...d-boost-44118/ |
do it once, do it right.
|
Originally Posted by Braineack
(Post 1144537)
do it once, do it right.
|
well yes. but there's no reason to build a system around a shitty turbo to find out it sucks then to have to figure a away to adapt the setup to something that actually works.
|
Originally Posted by Braineack
(Post 1144541)
well yes. but there's no reason to build a system around a shitty turbo to find out it sucks then to have to figure a away to adapt the setup to something that actually works.
You should get a 1.8. But so long as the turbo is a T3 flange, do it. because you could always swap to a smaller T3 flanged turbo. Again TurboBricks would love that turbo if its in good condition, if you dont want it, or whatever. They love the Diesel turbos for the 2.X motors. |
All times are GMT -4. The time now is 01:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands