|
probably, but an output circuit would have to be built to run it.
|
Originally Posted by Braineack
(Post 1003216)
probably, but an output circuit would have to be built to run it.
EDIT: quick search found this http://www.diyautotune.com/diypnp/ap...0-18bp-mt.html The VICS actuator should have vacuum at idle and changes state at 5000 RPM. We have used ALED as the output to control the VICS system at Connectorboard 4Q with RPM as a single output condition, a threshold of > 5000, a hysterisys of 300, "power on" set to 0, and "trigger value" set to 1. This all means that the output will activate at 5000 RPMs, won't turn back off until 4700 RPMs, is off when the MS is powred and the engine is started, and is activated when triggered |
relay control circuit
https://www.miataturbo.net/megasquir...ed-vics-32509/ |
Originally Posted by 240_to_miata
(Post 1003411)
relay control circuit
https://www.miataturbo.net/megasquir...ed-vics-32509/ |
Originally Posted by buffon01
(Post 1003418)
Thanks! :bigtu: I have an EBC laying around somewhere.
|
2 Attachment(s)
I might be late to the :party: but I was searching through pics from my build thread and this is the best pic I have of the inner side of the mani. That's the check valve right there i think?
Hope it helps? https://www.miataturbo.net/attachmen...1&d=1366762633 |
yeah, I had that in place. I have it running perfectly. was stupid easy.
|
I know this is an old thread but I am working on installing the VICS but using race capture to run it instead of a RPM switch or megasquirt (still using factory 1.6 ecu). We have the script in the RCP correct and the wiring to the relay correct, However I dont think we wired the solenoid correctly. Can you guys tell me what the pinout of the solenoid is? I followed this thread to get the vacuum properly hooked up. Now just checking the wiring.
|
| All times are GMT -4. The time now is 09:10 PM. |
© 2024 MH Sub I, LLC dba Internet Brands