Here's my dyno plot from a couple weekends ago. The car pulls hard and is a lot of fun. It could be leaned out a little on the bottom end, but I was getting the car prepped for a track day so I focused primarily on the top end. Trackspeed EFR 6258 kit on a junkyard 03 engine, MSLabs MS3, 3" artech exhaust, flat top manifold, FF 660cc injectors, precision 350hp intercooler. 10-11psi



Boost plot:

 

Nice numbers. Exactly what I would expect with good gas, 11psi, and that bottom end. Congrats

 

Think that looks relatively safe to run around with on the street? 16 degrees of timing up top.

 

Nice plot. Next time try to do 2k-redline so it's easier to compare to the "standard".
I'd say that's about as much as you'd ever want on stock rods. Mechanical empathy should allow it to hold up for quite some time.