Chinacharger 2560 @ 11psi on a 1999
1 Attachment(s)
Installed my GT2560 Churbo, not to happy with the numbers: 217whp 200tq @ 11.8 psi..................also a strange dip in the numbers between 3,800-4,300 rpms Dyno guy said its because my wastgate accuator set to high ( 9 psi ) I should lower it to 6 psi and use the MBC to control the difference ? Does this sound correct ? Set-up as follows: Downpipe 2-1/2, no cat, Borla Sport muffler RB midpipe, RX-7 460cc injectors EMB for control, 73% duty cycle @ wot
|
run it to redline next time. dip is probably the boost overshooting then leveling off, as you can see on the boost plot.
|
Thanks
|
damn i hope i put down more than that when i go to 12 pounds, i'm especially surprised since you have a 99. Still, that's not slow
|
Looks like my GT2554R graph... on a Mustang dyno. Churbo fail once again.
|
was that with a 2.25" exhaust?
|
Originally Posted by Savington
(Post 668929)
Looks like my GT2554R graph... on a Mustang dyno. Churbo fail once again.
|
Is this a ball bearing turbo with a 60mm 60 trim compressor wheel? Just wonderin, cause I made 209whp/ 206wtq at 11.9psi with a MS-1 parallel running my current turbo. This setup sounds pretty similar to mine, but now I'm running MS2 standalone instead of MS1 parallel. My turbo is a journal bearing unit with a 56mm 60 trim comp wheel. I also had my stock midpipe too. I guess your numbers aren't bad depending on actual turbo size.
|
Journal Bearing, 2.5 exhaust........still I was looking for at least 225whp based on the fact my old Saab turbo (.48/.49) made 217whp on 11psi. Churbo specs. Compressor a/r .60 (42.6-60 trim 51 ) Turbine a/r .64 ( 46.2-53 trim 79 )
|
All times are GMT -4. The time now is 11:01 PM. |
© 2024 MH Sub I, LLC dba Internet Brands