99-00 Bee-R Revlimiter Wiring
I got a Amazing deal on it so why not install it:fawk:
Bee-r this is the wiring Red wire: 12V+ Black wire: Earth Yellow wire: RPM Signal Green wire: Ignition signal. Red and Black- easy Yellow- Will the CamShaft Position Sensor pick up an RPM Signal? Green- On the ecu pinouts im looking at the ignitor has 2 outputs 3g and 3h which fires cyl 1-4 and 2-3, Would i tap into both of these and then run it to the green wire? |
Originally Posted by Dobzeh
(Post 1195466)
I got a Amazing deal on it so why not install it:fawk:
Bee-r this is the wiring Red wire: 12V+ Black wire: Earth Yellow wire: RPM Signal Green wire: Ignition signal. Red and Black- easy Yellow- Will the CamShaft Position Sensor pick up an RPM Signal? Green- On the ecu pinouts im looking at the ignitor has 2 outputs 3g and 3h which fires cyl 1-4 and 2-3, Would i tap into both of these and then run it to the green wire? And connecting both of the ignitors to the same wire would be really stupid, should be kind of obvious why. BTW CR.net has a lot of threads on this. They would probably be nicer than what you're about to get anyways. |
All times are GMT -4. The time now is 11:21 PM. |
© 2024 MH Sub I, LLC dba Internet Brands