Notices
ECUs and Tuning Discuss Engine Management, Tuning, & Programming

99-00 Bee-R Revlimiter Wiring

Thread Tools
 
Search this Thread
 
Old Jan 11, 2015 | 05:35 PM
  #1  
Dobzeh's Avatar
Thread Starter
Newb
 
Joined: Jun 2014
Posts: 43
Total Cats: -32
Default 99-00 Bee-R Revlimiter Wiring

I got a Amazing deal on it so why not install it
Bee-r this is the wiring
Red wire: 12V+
Black wire: Earth
Yellow wire: RPM Signal
Green wire: Ignition signal.

Red and Black- easy
Yellow- Will the CamShaft Position Sensor pick up an RPM Signal?
Green- On the ecu pinouts im looking at the ignitor has 2 outputs 3g and 3h which fires cyl 1-4 and 2-3, Would i tap into both of these and then run it to the green wire?
Reply
Leave a poscat -1 Leave a negcat
Old Jan 12, 2015 | 12:05 AM
  #2  
aidandj's Avatar
SADFab Destructive Testing Engineer
iTrader: (5)
 
Joined: Apr 2014
Posts: 18,643
Total Cats: 1,870
From: Beaverton, USA
Default

Originally Posted by Dobzeh
I got a Amazing deal on it so why not install it
Bee-r this is the wiring
Red wire: 12V+
Black wire: Earth
Yellow wire: RPM Signal
Green wire: Ignition signal.

Red and Black- easy
Yellow- Will the CamShaft Position Sensor pick up an RPM Signal?
Green- On the ecu pinouts im looking at the ignitor has 2 outputs 3g and 3h which fires cyl 1-4 and 2-3, Would i tap into both of these and then run it to the green wire?
RPM should be able to be pulled from the diagnostic connector.

And connecting both of the ignitors to the same wire would be really stupid, should be kind of obvious why. BTW CR.net has a lot of threads on this. They would probably be nicer than what you're about to get anyways.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
Oct 26, 2018 11:00 PM
nick470
MEGAsquirt
7
Jun 16, 2017 01:53 PM
slomiata
MEGAsquirt
5
Oct 7, 2015 01:11 PM
viriiguy
General Miata Chat
5
Sep 28, 2015 07:39 PM
btabor
ECUs and Tuning
10
Sep 28, 2015 05:33 PM




All times are GMT -4. The time now is 09:27 AM.