Any update on the newest batch of PnP units? What's the pricing like? Getting excited over the thought of a cheaper standalone option.
|
Originally Posted by kimkam120
(Post 1500901)
Any update on the newest batch of PnP units? What's the pricing like? Getting excited over the thought of a cheaper standalone option.
Pricing will be the same, $240 USD :) |
Fired up and drove my car last night for the first time on Speeduino. So far I am pretty happy with the whole thing. Gonna start making the installation more permanent and add some features like tps and wideband. Also, need to get my ac triggering again.
|
Is there no AC idle up?
|
Originally Posted by huesmann
(Post 1501393)
Is there no AC idle up?
|
Originally Posted by iantboyd
(Post 1501195)
Fired up and drove my car last night for the first time on Speeduino. So far I am pretty happy with the whole thing. Gonna start making the installation more permanent and add some features like tps and wideband. Also, need to get my ac triggering again.
Still need to figure out how get it to idle up when the compressor is turned on. Idle up was added to the last software upgrade, but I haven't checked what is required to make it work. |
Originally Posted by Lztaas
(Post 1502860)
Is your AC not turining on or not idling up? I built my Speeduino and needed to solder a jumper wire in my Speeduino to make my AC work. Still need to figure out how get it to idle up when the compressor is turned on. Idle up was added to the last software upgrade, but I haven't checked what is required to make it work. originally was doing nothing. I too had to solder a jumper and a diode in. So it functions fine now, but no idle up. I need to investigate more. |
|
Originally Posted by lsdlsd88
(Post 1508508)
|
Hey, we shelved our speeduino for a bit but would like to dust it off and give it another go.
We are looking at installing a mazdaspeed miata engine. Would speeduino be able to use the crank trigger as well as the cam position sensor from the msm engine rather than using the 1.6 CAS, essentially wiring it like in the vvt swap master thread? |
Yes. The NB system is supported.
|
My unit was one of the first production beta tests
does it need any pins moved or anything added? |
depends, do you have any issues? if it ain't broke.. I'd recommend to update the firmware :)
|
Thread bump!
How is everyone going with thier speedies? I'm just about to fit a no2c to my 1600 turbo.. Does the no2c need any other mods to the board? Does it need the 1k resistor for tach? Do I just wire the fuel pump wire direct to the no2c (after removing the St fuse)? |
All times are GMT -4. The time now is 02:22 PM. |
© 2024 MH Sub I, LLC dba Internet Brands