MegaSquirt 3 DIY/Tuner Studio CLT Sensor Setting Problem
Thread Starter
Newb
Joined: Oct 2019
Posts: 25
Total Cats: 0
From: New Jersey
MegaSquirt 3 DIY/Tuner Studio CLT Sensor Setting Problem
I'm running into this weird issue when setting the calibrations for the coolant temp sensor. According to TruboKitty's instructions. I should set "Coolant Temperature Sensor" and set "Common Sensor Values" To "RX-7_CLT(S4 & S5)".
Though when I press "Write to Controller", close the tab, then go back into the tab. The "Common Sensor Values" is set to "RX-7_AFM(S5 in AFM)" instead. This doesn't make sense why tuner studio is resetting it. The values on both tables are the same but idk if it's wrong to use the AFM one. Does anyone have any ideas?
- For 90-97:
From ‘Common Sensor Values’, select: RX-7_CLT(S4 & S5).
Though when I press "Write to Controller", close the tab, then go back into the tab. The "Common Sensor Values" is set to "RX-7_AFM(S5 in AFM)" instead. This doesn't make sense why tuner studio is resetting it. The values on both tables are the same but idk if it's wrong to use the AFM one. Does anyone have any ideas?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
