Because CNC
#256
Elite Member
iTrader: (8)
Join Date: Dec 2008
Location: Kingston, Ontario
Posts: 2,910
Total Cats: 51
whats going on between 3 and 4 grand on the n/a plot?
I assume its because of the cams coming into efficiency.
Have you tried a shorter runner intake manifold with setups like this to give it a bit more jam up top (flatter torque), with even more inefficiency in the <3000rpm street car range?
iirc, Falcon's 1.6L would be the only example of what im talking about and its chart was pretty similar, but with a 1.6L.
I assume its because of the cams coming into efficiency.
Have you tried a shorter runner intake manifold with setups like this to give it a bit more jam up top (flatter torque), with even more inefficiency in the <3000rpm street car range?
iirc, Falcon's 1.6L would be the only example of what im talking about and its chart was pretty similar, but with a 1.6L.
#258
whats going on between 3 and 4 grand on the n/a plot?
I assume its because of the cams coming into efficiency.
Have you tried a shorter runner intake manifold with setups like this to give it a bit more jam up top (flatter torque), with even more inefficiency in the <3000rpm street car range?
iirc, Falcon's 1.6L would be the only example of what im talking about and its chart was pretty similar, but with a 1.6L.
I assume its because of the cams coming into efficiency.
Have you tried a shorter runner intake manifold with setups like this to give it a bit more jam up top (flatter torque), with even more inefficiency in the <3000rpm street car range?
iirc, Falcon's 1.6L would be the only example of what im talking about and its chart was pretty similar, but with a 1.6L.
What every "grand plan" for any B series Miata engine has to take into account is the low rod ratio and poor head flow. An NB will never be a free flowing high RPM screamer. The same OEM forged crank that will tolerate nearly 500whp at 7500rpm will explode at 8700rpm @ 190whp. The stock manifold is pretty close to the correct dimension, just a tad larger cross section in runner and straighter paths needed. The TB mounting flange offset is the main issue you want to correct.
The OEM manifold is folded and scrunched to clear the hood, ABS pump, EGR and other bits. Just get rid of the obstructions to get good flow paths and you have a good manifold.
__________________
#259
In car from last weekend with the Rotrex removed. Car details in the youtube notes. About 170whp on pump gas with this engine. Down on power from the 185whp or so it should make because the piston/rings used were not our standard ST/XX. Burning some oil where we usually get no oil consumption. Anyway, I wanted to do one last run N/A before we put the K20A2 in it. Another 50whp and vtak should be fun.
__________________