bp4w head on bpz3 bottom, what do I need?
As above.
Car is already running 6speed and that starter on a bp4w and is controlled by ms3. Looking to build a block beside the car. Are all the sensors interchangeable / fit with my current harness between the 2 blocks, or do I need to rebuild harness / ms / change sensors? Is the bpz3 head gasket recommended or is a bp4w hg with reroute the way to go? Thanks a lot! |
<p>I'm about to run this exact setup. I am running the bp4w hg with a reroute, but I also already had the supplies for the reroute. It should all be the same.</p>
|
same
|
The 99-00 and 01-05 should all have the same sensors. I think that the cam sensor moved, so you might need to extend the harness. You'll need to run 2 wires to control the VVT solenoid, as well.
|
<p>
Originally Posted by Dunning Kruger Affect
(Post 1253128)
The 99-00 and 01-05 should all have the same sensors. I think that the cam sensor moved, so you might need to extend the harness. You'll need to run 2 wires to control the VVT solenoid, as well.
|
The 99-00 and 01-05 should all have the same sensors. I think that the cam sensor moved, so you might need to shorten the harness. You'll need to tuck away the 2 wires that control the VVT solenoid, as well.
|
The blocks are externally identical for your purposes
|
All times are GMT -4. The time now is 06:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands