Found a Honda manifold.....
#1
Junior Member
Thread Starter
iTrader: (6)
Join Date: Apr 2008
Location: Goodrich, MI
Posts: 189
Total Cats: 5
Found a Honda manifold.....
Hey guys, I found the following manifold on craigslist and bought it for $20..... that being said do you think it would be worth throwing a B6 flange on it and running it? It is for a D16, has a pretty good size plenum and velocity stacks. Im sure its an Ebay special but the design looks a lot like what BEGi sells which is why i took a chance on it. Before anyone asks, the runners are only 1mm off so it would be easy to line them up, and It will be used on a high boost/high horsepower car. If the general consensus is that it looks to be a worth wile project, im going to hack up the plenum to smooth out the velocity stacks (where there attached is a ledge which is hard to photograph) and weld on a new/old flange after sandblasting to remove that shitastic finish.
Thanks,
Mike
Thanks,
Mike
#2
Junior Member
Thread Starter
iTrader: (6)
Join Date: Apr 2008
Location: Goodrich, MI
Posts: 189
Total Cats: 5
It appears to be similar to this manifold.
D15 D16 Honda Civic 92 93 94 95 Air Intake Manifold | eBay
D15 D16 Honda Civic 92 93 94 95 Air Intake Manifold | eBay
#8
I mean seriously... it's so blatant it's not even funny. And people pay $700 for that hackery. Awesome. You can even tell just looking at it exactly what's done to it for Miata use.
But hey, at least now i know where to go to get a Begi manifold for my buddy's 93 that's getting my old built motor that i'll be working on. Much win.
But hey, at least now i know where to go to get a Begi manifold for my buddy's 93 that's getting my old built motor that i'll be working on. Much win.
Thread
Thread Starter
Forum
Replies
Last Post
elesjuan
Build Threads
9
11-14-2018 12:18 PM
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM