Delhole94

iTrader: (3)

I have searched on here and on the internet and havent found my answer. I have seen specs for the 1.6 and 1.8 rods are the same.

should be 133mm long with a 20mm pin hole and a big end bore of right around 48mm.

What I havent found is the big end thickness and the piston end thickness. Does anyone know this or can measure a rod they have availible with a digital caliper for me. Possibly a rod spec sheet from eagle or carrillo.

Thanks

hustler

iTrader: (6)

not sure on the specifics, but my machinist said they looked good and did well on the stretch test.

TravisR

iTrader: (9)

/