does anybody have the dwell tables for GM LS2 heavy duty D585 coils for a Hydra? thanks!

 

https://www.miataturbo.net/diy-turbo...8/#post1380088

 

hey thanks wackbards for the reply. i have looked around for a while now and but still can not figure it out. it seems most ems have a table with rpm and voltage for the dwell. i guess that hydra only uses voltage. so i still don't know what the dwell should look like without the rpm table.

 

I don't know anything about Hydra, but 10 seconds of googling turned this up. Maybe it will point you in the right direction.

Hydra EMS :: Nemesis 2.7 > Manual > Engine Speed Dwell Trim

 

thanks again for taking the time to look and respond wackbards. that is good information but like i said i have spent quite a bit of time online looking. yes i found that link in the first 10 seconds of googling. that is one of the ways i know that hydra just uses voltage and not rpm and voltages in their dwell settings. the link tells me how to change the settings but i am looking for the correct settings for the LS2 coils.

i was kind of hoping someone who knows about the hydra and the coils could give me the right tables.