Fuel is getting into oil catch can
#1
Bannisheded
Thread Starter
iTrader: (33)
Join Date: Jan 2009
Location: San Jose, CA
Posts: 1,056
Total Cats: -3
Fuel is getting into oil catch can
For the second time after emptying out my oil catch can which was full to the brim! about 99% of the fluid inside of it was fuel while the rest 1% was oil residue.
I know this isnt normal but should i suspect my current set-up?
Its a freshly fully built motor which has only 3k+ miles so far.
running e85
1000cc injectors
walbro 255 FP
Could it be the 1000cc's that are pushing way to much fuel?
Is this something other forum members have encountered before?
I know this isnt normal but should i suspect my current set-up?
Its a freshly fully built motor which has only 3k+ miles so far.
running e85
1000cc injectors
walbro 255 FP
Could it be the 1000cc's that are pushing way to much fuel?
Is this something other forum members have encountered before?
Last edited by railz; 01-03-2011 at 02:07 PM.
#5
Well...most of the "gunk" that you find in a catch can is condensed fuel and water vapors...not really a lot of pure oil content. Might want to send your oil off for analysis too. Like Hussy says, how are the AFRs? How many miles since you installed it/checked it last? How full was it? How big is the catch can?
#7
Bannisheded
Thread Starter
iTrader: (33)
Join Date: Jan 2009
Location: San Jose, CA
Posts: 1,056
Total Cats: -3
AFR's are spot on normal. i changed the oil not to long ago but even before the oil change it was doing the same.
The can was full to the top and this was all with less then 100miles of driving. Its as big as a 16oz bottle
The can was full to the top and this was all with less then 100miles of driving. Its as big as a 16oz bottle
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM