What way does the head gasket go on.
#1
Senior Member
Thread Starter
iTrader: (11)
Join Date: Sep 2007
Location: Killen, AL, 35645
Posts: 794
Total Cats: 10
What way does the head gasket go on.
Damn, I think I might have it installed the incorrect way, but does anybody have any pictures showing the proper installation of a head gasket on a 99-2000 motor. I know there is one particular coolant channel that will get blocked off if it is installed incorrectly.
#2
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,046
Total Cats: 6,607
There's one particular OIL channel that will get blocked off. Namely the one supplying oil to the head.
This is an '01, but the oil hole is in the same location. I've circled the diagonal slot in the HG that matches up with it.
This is an '01, but the oil hole is in the same location. I've circled the diagonal slot in the HG that matches up with it.
#5
Cpt. Slow
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,204
Total Cats: 1,138
Oil feed/hole looks exactly the same on the 1.6 though. It's how I've always lined it up, but apparently there are other holes that would be misaligned if it were backwards? Never cared to check. The one time I'd try it to see, is the time I'd accidentally leave it that way.
#6
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,046
Total Cats: 6,607
Note that these are viewed as though you are looking at the head, upside-down on a bench.
Thread
Thread Starter
Forum
Replies
Last Post