how much boost for say 200lbs/ft of torque
Hi, i'm running a 1.8 NA mx5 with a T25 (.48) turbo, 460cc low imp injectors, adaptronic management etc etc and i'm currently running 10psi of boost.
I just wondered what amounts you guys have safely run on a T25 and what kind of boost i'd need to be running to produce 200lbs/ft of torque or as close to it as possible. thanks in advance Tom |
~10psi
|
what kinda psi = bhp/torque are you running scott?
|
On a .49a/r T25 you won't make 200wtq. On a .64a/r T25 with a 60mm or larger compressor, you'll need at least 12psi to hit the 200wtq mark.
Note that's wtq - you can make 200whp on the .49a/r turbo at ~15psi. |
I'd say 10-15psi depending on the timing map
|
Originally Posted by pusherman
(Post 743009)
what kinda psi = bhp/torque are you running scott?
It takes a bit more on my turbo and smaller motor. this is my t3 on my 1.6L running 10psi vs a 94 motor running a .84/.64 t25 at 10psi. http://www.boostedmiata.com/gallery2..._Lars_dyno.jpg |
good times, cheers for the replys all.
I'm just road mapping the car and may increase boost a little to 12psi and start addressing the timing map and see where I go from there. cheers Tom |
I recently turned up the boost from 10 to 12 psi on my 99. Haven't been on dyno yet but the jump from 10 to 12 makes a huge difference in power! I think I found the sweet spot for the 2854 churbo.
:drool: |
oo nice... well i'm gona get it through the MOT then and then try and wind it up a bit
|
Originally Posted by flounder
(Post 743731)
i recently turned up the boost from 10 to 12 psi on my 99. Haven't been on dyno yet but the jump from 10 to 12 makes a huge difference in power! I think i found the sweet spot for the 2854 churbo.
:drool: |
It's from the begi shanghai kit.
|
All times are GMT -4. The time now is 07:31 PM. |
© 2024 MH Sub I, LLC dba Internet Brands